XBOX HAQUE: PART TWO

Male speaker: So now that we got our controller opened up and I showed you guys where these socket points are, we are actually going to set the controller aside and work on assembling our switch. This is just pretty much a prep step you could use before or after in the kit that we are setting up the switch will be pretty assembled for you guys. We have a single momentary switch, a thing of shrink wrap when you apply heat to this it shrinks around the wire and some wire. You should then measure the amount of heat shrink to about half an inch and about there. I would just strip the ends. I usually give the wire a little twist, a little twist on it. I will take our rosin flux pen add a little bit to the end of your wire and tend, that's it. So I've taped the switch down so it doesn't move around on me, pretty much set the wire through the hole around a little bend. Knocking, hey that's a nice one. Little push.

Connecting wires to the switch, shrink wrap or heat shrink the end connectors and now we are going to solder the two points on to the motherboard.

And you apply. Now we take our bottom shelf keep it on somewhere safe.

SEE THE NEXT PART ON: REVOLUTION NUMBER THREE.COM